How to operate the clutch of a mining truck correctly

How to operate the clutch of a mining truck correctly?

1. First gear start (not high-grade start);

2. When shifting, the clutch should be fast and slow (increase the speed when increasing the gear, reduce the speed when reducing the gear, and do not jump the gear operation);

3. Due to the large temperature difference between day and night in Xinjiang, check the exhaust of the booster, step on the clutch pedal quickly, listen to whether the exhaust sound is normal, if the exhaust lag should be slightly slow step on the accelerator, if the exhaust lag long should replace the booster;

4. Not long time semi linkage;

5. Do not put the foot on the clutch pedal when not using the clutch;

6. Don't slam on the gas pedal at any time;

7. The "two-foot clutch" operation mode should be adopted when shifting;

8. Check the oil inside the clutch master pump regularly, and do not force it to be used when the oil is not enough;

9. No overload;

10. When going down a high slope or continuous downhill, do not run in a neutral gear. If you feel too fast with some brakes, do not slam on the brakes;

11. Dust should be cleaned regularly in the clutch environment;

12. After checking the feel of the foot to check the free travel of the clutch pedal, it should be within the range of 10-20mm. If the feeling is too large or too small, professionals should be asked to adjust the operating mechanism of the clutch in time, and the new driven disc assembly should be replaced if it cannot be adjusted.

13. Check regularly (not more than 3 months), driven disc wear, such as fast grinding to the rivet, immediately replace;

14. Select the matching clutch assembly when replacing the new part;

15. Use the original manufacturer's clutch assembly;

16. Precautions for starting half slope:

     ①Step on the clutch (to the end), hang one gear;

     ②Slow lift clutch, feel the body began to shake, stop in this position;

     ③Slowly add the throttle, and cooperate with the left foot clutch (to the car is not so violent       shaking);

     ④Keep the clutch and throttle position, gently hand brake;

     ⑤Feel the car has a forward trend, decisively let go of the brake;

     ⑥Loose clutch at the same time refueling door (remember not to always oil not loose clutch, so easy to burn), successfully complete the start;

     ⑦Heavy load uphill, do not hang on the slope, should be in advance according to the slope to switch the low gear uphill.